Congratulations, you bought the best clutch system for your R6.
For best results, this installation should be performed by an experienced
mechanic.
1. Read this instruction with photos before you start. Check if the kit
includes all parts.
2. Remove the old clutch ( according Yamaha workshop manual ), completely
clean threads on the shaft . Clean these parts with brake cleaner.
3. Check to see if the steel balls are in their pockets. Use two clutch
springs and upper retainers to pre-mount both parts of clutch drum together.
Please note the inner and outer hub is marked.
4. Install to gearbox shaft.
5. The kit includes small parts for mounting. They are attached with a zip tie
in position how to mount them. Remove them, remove zip tie and mount them. Nut
torque is 120 Nm, use Loctite No. 262.
6. Remove the two springs with caps
7. Install clutch plates . This kit is designed for STD clutch plates.
DON´T mount the first ( from crankcase ) 2,25mm steel plate!!!!!! The other
plates mount to position as usual. 
8. Mount the pressure plate with pull-rod. Install clutch springs with kit
retainers and M5x30 kit bolts ( torque 6 - 8 Nm ). 
9. Check the clearance between pressure plate and clutch drum in pressure
plates hole. The correct clearance is 1,0 – 1,5 mm. When the clearance is
smaller, remove one pc. of 2.0mm steel plate and replace it with 2.25mm ( it
stayed by mounting ) steel plate. If is it still not enough, change all
friction plates to new ones.
10. Install clutch cover according Yamaha workshop manual, and go back to
track.